Aeon Labs Z-Stick Instrucciones de operaciones descargar pdf (Pagina 4)

• SerialAPI-Mode : Allowing a Host Processor To Take Control of the Z-Stick and Take Part in

the Z-Wave Network

1. To initiate SerialAPI-Mode, plug the Z-Stick into the USB connector of the host.

Note: While in SerialAPI-mode, the Z-Stick is always listening (it is awake and always in

RX receive mode) for instructions and acts as a Z-Wave adapter and responds to

commands sent through USB by the host processor software.

Note: Pressing the Z-Stick button will not have any effect while in SerialAPI-Mode.

• Other Functions:

• Factory reset on the Z-Stick: This must be done through the host software which takes

control of the Z-Stick USB adapter while the Z-Stick is in SerialAPI-Mode. Please consult

the instruction manual of the host software to perform a network reset (i.e. factory

reset on the Z-Stick). This function can only be preformed via the host software.

• Add the Z-Stick to a pre-existing Z-Wave network: This must be done through the host

software which takes control of the Z-Stick USB adapter while the Z-Stick is in SerialAPI-

Mode. Please consult the instruction manual of the host software to add the Z-Stick to a

pre-existing Z-Wave network (i.e. “Learn”, “Sync”, “Add as Secondary Controller”, etc.).

This function can only be preformed via the host software.

1 2 3 4

Sin comentarios

Aeon Labs Z-Stick Instrucciones de operaciones Pagina 4